Master Series Stuck and Stuffed Stockade with Dildo, Grey (AE970)

Super kink! Loads of fun. Mine was missing 2 of the bolts but I just went to my quads bolt kit id bought and found a couple.

Supplied with a sturdy bag for transport, the item is comprised of a central telescopic mast . This is the overall horizontal lengthy bar. For users considering this purchase , it should be known assembly is partially reconfigurable into a few concepts. However as this assembles its important to note the inside diameter of accessories come in 2 sizes. Starting with the forced hands and knee position “Doggie style” , you assemble the mast using the two pipes supplied, one is the larger tube intended for the ankle side application, and having a friction binding set screw to lock the length, and the other tube , smaller insertable, as the top. Now loading the accessories can only be put onto the tube from either end, but due to the set screw it stops the accessories from going over the mid point threshold. In the assembly as shown in the picture, the double adjustable axis for the ‘stuffing’ device uses the same set screw to friction lock the height of the supplied dildo to the accessory bar which is in turn , another bar which attachs to the main mast.. So its important to know, that the design is freely adjustable but however for those who like to play rough, dont expect the assembly to stay put as it can easily be loosened off without touching the screw. *we will come back to this*. Now the pipe quality is excellent and the fricrion screw system is designed by welding a threaded nut to the pipe, giving the screw ample threads to apply plenty of pressure. However I did notice that the welds were not excellent and the threaded nut was not at a near perfect angle on all of them. So the set screw was crooked on the kit. The ankle bar aligning onto only the larger mast portion, along with the stuffing attachment bar are interchangable position giving you the ability to have the sub user to be propogated in the air or seated bent knee style on belly. The shaft to which the Dildo is attached could become over inserted so placement is important. While in the basic configuration, the sub bodt movement loosened off the assembly for the Dildo and the entire assembly folded on its own axis and fell uncontrollably out. Kind of something to revisit later. The straps are traditional Poly urethane faux leather , good enough quality but desired a bit in length for aveeage adult users with thicker ankles were nearing the last adjustable points before they would have to replace them. The leg attachment bar is also something that the sub can loosen off using the body to torque loose the set screw. We all like to make our subs play nice with our toys but during training…things can get loose. I did want to note that configuration changes were ever so adjuatable, for instance the assembly can be used verticle and horizontal. If you make the sub stand, you not only assemble from behind the user but have now posture control too. Some of the accessories not talked about like the wrist spreader bar will double onto the posture collar bar and that is what gives this a slight change in design intent. Now as promised. We talked about revisiting some of the points discussed, lets address the friction points of the set screws, if you were to change out the set screws to hardened steel grade 8 bolts, and say find your best and most frequent positions, one can drill a hole in the intended spot instead of having the pipe being pressured it would be secured properly. Why not use the supplied screw? Well that torsion I was talking about it could shear the bolt off. But good luck on a grade 8 std thread.. or one could use a cotter style pin system.

Bought as a gift